Bosch GCM12SD Manual Del Usuario página 11

BM 2610007877 08-10:BM 2610007877 08-10.qxp 8/24/10 1:04 PM Page 11
Tools Needed for Assembly and Alignment
Combination Square Must Be True - Checking Combination Square
1. Position square and
draw a light line
3/4" board with
straight top edge
Combination Square
10mm Socket
(supplied)
NOTE: A 6mm and a 4mm hex key can be
substituted for the supplied 6/4mm hex key.
drawn line
ssembly
#2 Phillips Screwdriver
2. Flip square (shown in dotted position)
3. Check edge of flipped square against
the drawn line. There should be no gap
or overlap at the bottom end.
no gap or overlap
11.
6/4mm Hex Key
(supplied)