Maintenance - Husqvarna K 535i Manual De Usuario

1. Make sure the pipe does not move during cutting.
2. Cut with section "I".
III
3. Make sure that the cut opens to prevent pinching.
4. Move to side II and cut from section I to the bottom
of the pipe.
5. Move to side III and cut the remaining part of the
pipe.
6. Make sure the pipe is kept in place correctly. The
end of the pipe must move down during the cutting.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
WARNING:
you do maintenance on the product.
745 - 008 - 12.11.2018
I
II

Maintenance

Read and understand the
Remove the battery before
To prevent pinching
WARNING:
during a cutting operation. A cut that closes
can cause pinching, which can cause a
kickback or damage to the cutting blade.
WARNING:
blade is put in a cut that was there before.
• Make sure that the work piece cannot move during a
cutting operation.
• Make sure that the work piece is held to keep the cut
open during a cutting operation.
• Make an estimate of the possible movement of the
work piece during the last phase of the cutting
operation.
• Make sure that the cut opens during the cutting
operation.
To manage dust
• The product has a low flushing water kit. Use wet
cutting when possible. See instructions in
connect coolant water on page 15 . The correct flow
is different for different types of tasks. If the water
hose comes off at the supply source, the supplied
water pressure can be too high. See
on page 23 for recommended water pressure.
• Adjust the water flow with the valve.
WARNING:
correctly can decrease the product life cycle
and increase the risk of accidents. All
servicing and/or repair work must also be
done by a professional. Turn to your
servicing dealer for more information.
Do not let the cut close
Be careful when the cutting
To
Technical data
Failure to do maintenance
19