Stenner Pumps S Serie Manual De Instalación Y Mantenimiento página 54

OPERATING DISPLAY
After selecting "Run Pump" in the Main Menu and pressing ENTER, the pump will go into operating
mode and start running based on the programmed settings.
• If a password is set, the pump controls will lock out after 60 seconds if there is no keypad activity.
• To unlock the pump, press ENTER for 2 seconds. The pump will display a prompt to enter a password.
If using Modbus, refer to the Modbus manual for Run Pump.
In operating mode, the following functions are available when the pump is unlocked or no password
is set:
Button
UP
DOWN
PRIME
ON/OFF
BACK
ENTER
S Series FW 4.01.02 US and Canada 800.683.2378, International 904.641.1666 www.stenner.com
Operating Mode Function
Increases the speed percent in the Manual mode
Decreases the speed percent in the Manual mode
Runs pump at 100% speed while button is pressed
Turns pump control ON or OFF
WARNING: DOES NOT REMOVE POWER
Cycles the display to show different units of output
Press and hold for 2 seconds to go to the Main Menu
54