Stenner Pumps S Serie Manual De Instalación Y Mantenimiento página 38

CONTROL MODES MENU
PULSE
page 1 of 2
Operator can configure the pump to run for a specified period of time when it receives a specified
number of signals from a dry contact or an open collector input.
To program the pump for Pulse control mode, set the activation parameters in Program Settings, return to the Pulse
Control menu and program the desired options under Alarm Settings, then exit to the Main Menu via the Go To Main
Menu option.
The minimum allowable run time is 20.0 seconds.
A signal overrun occurs when the pump receives sufficient pulses to activate another run cycle while
the pump is already in a run cycle. This means that the process flow is greater than what the program settings allow for.
The pump will ignore an activation while it is in a run cycle. A signal overrun condition will lead to incorrect dosing.
NAVIGATION
Moves up in a menu, toggles
between options, or increase a value
Holding the or button causes the numbers to change rapidly.
Control Mode
- 4-20mA
- 0-10VDC
- Pulse
S Series FW 4.01.02 US and Canada 800.683.2378, International 904.641.1666 www.stenner.com
continued
Moves down in a menu, toggles
between options, or decreases a value
Pulse
- Program Settings
- Alarm Settings
- Go to Main Menu
Pulse
- Program Settings
- Alarm Settings
- Go to Main Menu
Pulse
- Program Settings
- Alarm Settings
- Go to Main Menu
To Main Menu
Moves one step back in
a menu, when permitted
Continued on next page
No
Alarm on Overrun?
Yes
yes/no set
Yes
Select "Yes" to shut off the pump in the
Stop Pump on H ALM?
event of a signal overrun alarm. Select
Yes
"No" to allow the pump to continue to run
yes/no set
in the event of a signal overrun alarm.
To Pulse menu
38
Sets a value in a menu
Returns display to the Pulse
menu without enabling the
signal overrun alarm.