Hilti TE 60-AVR Manual De Instrucciones página 8

1.2.3 Symbols in illustrations
The following symbols are used in illustrations:
These numbers refer to the illustrations at the beginning of these
operating instructions.
The numbers in illustrations refer to important work steps or to com-
ponents important for the work steps. In the text, the corresponding
numbers draw attention to these work steps or components, e.g. (3).
Item reference numbers are used in the overview illustration and
refer to the numbers used in the key in the product overview sec-
tion.
This symbol is intended to draw your special attention to certain
points for handling the product.
1.3 Product-dependent symbols
1.3.1 Symbols on the product
The following symbols are used on the product:
Drilling without hammering action
Drilling with hammering action (hammer drilling)
Chiseling
Chisel positioning
Forward / reverse
Protection class II (double-insulated)
Protective earth / ground (only TE 60-AVR)
Diameter
Rated speed under no load
Revolutions per minute
1.4 Product information
Hilti products are designed for professional use and may be operated, ser-
viced and maintained only by trained, authorized personnel. This personnel
must be informed of any particular hazards that may be encountered. The
product and its ancillary equipment may present hazards when used incor-
rectly by untrained personnel or when used not as directed.
The type designation and serial number are printed on the type identification
plate.
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to inquire about the product.
Product information → page 3
2 English 2134961
*2134961*