Hilti TE 60-AVR Manual De Instrucciones página 20

Trouble or fault
Product does not
develop full power.
The drill bit does not
rotate.
The drill bit cannot
be released.
Product does not
start.
14 English
Possible cause
The extension cord
is too long and/or its
gauge is inadequate.
The control switch is not
fully pressed.
The voltage provided by
the electric supply is too
low.
The reduced-power
(50% power) button is
engaged.
The function selector
switch is not correctly
engaged, is set to "Chis-
eling" , or is set to
"Chisel positioning"
The chuck is not pulled
back fully.
The side handle is not
fitted correctly.
Interruption in the elec-
tric supply.
The electronic restart
interlock is activated
after an interruption in
the electric supply.
The supply cord or plug
is defective.
Action to be taken
▶ Use an extension cord
of an approved length
and/or of adequate
gauge.
▶ Press the control
switch as far as it will
go.
▶ Connect the combi-
hammer to a different
electric supply.
▶ Press the reduced-
power button.
▶ Move the function
selector switch to
the "Hammer drilling"
position while the
motor is not rotating.
.
▶ Pull the tool lock back
as far as it will go and
remove the accessory
tool.
▶ Release the side
handle and refit it
correctly so that the
clamping band and
side handle engage in
the recess.
▶ Plug in another electric
tool or appliance
and check whether it
works.
▶ Switch the product off
and then on again.
▶ Have the supply cord
or the plug checked
by a trained elec-
trical specialist and
replaced if necessary.
2134961
*2134961*