Hilti TE 60-AVR Manual De Instrucciones página 16

5.1.1 Fitting the side handle
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the tool holder from the front
and into the recess provided.
3. Bring the side handle into the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.1.2 Fitting the depth gauge (optional)
1. Release the side handle clamping band by turning the handle grip.
2. Slide the depth gauge from the front into the 2 guide holes provided.
3. Tighten the side handle clamping band by turning the handle grip.
5.1.3 Setting the power level (optional)
TE 60-ATC/AVR
After the supply cord is connected to the AC supply, the product is
always set by default to full power.
1. Press the power reduction button. The product runs at reduced power
(50 %).
▶ The reduced-power LED lights.
2. Press the power reduction button again. The product runs at full power.
▶ The reduced-power LED goes out.
5.1.4 Fitting the accessory tool
1. Apply a little grease to the connection end of the accessory tool.
▶ Use only genuine Hilti grease. Using the wrong grease can result in
damage to the product.
2. Push the accessory tool into the tool holder as far as it will go (until it
engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it
is securely engaged.
▶ The product is ready for use.
5.1.5 Removing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Pull the tool lock back as far as it will go and remove the accessory tool.
10 English
3
4
5
6
6
2134961
*2134961*