Idiomas disponibles
Idiomas disponibles
i)
The product is not a toy. Children should be watched to ensure that they do
not play with the appliance.
1.3.
Safe use of the device
a)
Do not overload the device. Use tools that are suitable for the application. A
correctly selected product will do a better and safer job for which it was
designed.
b)
Do not use the device if the ON/OFF switch does not function properly (does
not turn on and off). Units that cannot be controlled by the switch are unsafe,
cannot operate, and must be repaired.
c)
Disconnect the device from the power supply before adjusting, cleaning, or
servicing. This precaution reduces the risk of accidental start-up.
d)
Keep unused product out of the reach of children and anyone unfamiliar with
the device or this manual. Products are dangerous when used by
inexperienced users.
e)
Keep the product in good working order. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the device). If damaged,
return the device for repair before use.
f)
Keep the product out of the reach of children.
g)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
h)
To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
i)
When transporting or moving the device from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the device is used.
j)
Avoid situations in which the device stops under heavy loads during operation.
This can cause overheating of the drive elements and consequent damage to
the equipment.
k)
Do not touch any moving parts or accessories unless the device is unplugged.
l)
Do not leave the device switched on unattended.
m) Clean the device regularly to prevent permanent dirt build-up.
n)
The provided value of vibration emission is measured according to the
standard measurement methods. The value of vibration emission may change
if the unit is used under different environmental conditions.
o)
If you notice any leakage from the machine or hoses, immediately disconnect
the power supply and correct the fault.
p)
Do not obstruct the air inlet or outlet.
q)
Do not start up an empty unit.
r)
Do not tamper with the device to alter its performance or design.
