Idiomas disponibles
Idiomas disponibles
5. Turn the control cage (B) clockwise, if the hotspot is
too much on the right side.
6. Turn the control cage (B) counterclockwise, if the
hotspot is too much on the left side.
2070 - 003 - 16.03.2023
7. Make sure that the hotspot is equaly applied on the
surface for correct adjustment.
8. Tighten the cage clamps when the control cage is
in correct position. Rotate the blastwheel with your
hand to make sure that the control cage does not
touch the blastwheel.
9. Install the feed spout, the 2 washers and the 2
screws.
To stop the product
1. Push the abrasive control cable to close the abrasive
To operate the abrasive valve on
valve. Refer to
page 14 .
2. Push the OFF button (B) to stop the blast motor.
A
B
21
