Idiomas disponibles
Idiomas disponibles
2. Loosen the 2 adjustment screws at the rear to set
the correct height.
3. Tighten the screws.
To adjust the height of the brush list
seals
The correct height adjustment of the brush lists is 1 mm/
0.04 in from the surface.
1. Loosen the 4 screws that holds the brush list.
2070 - 003 - 16.03.2023
2. Adjust the height of the brush list.
3. Tighten the 4 screws.
Abrasive
Speak to your Husqvarna dealer for the selection of
correct abrasive for your surface operation. Refer to
Approved abrasive on page 31 .
Abrasive separator 1-10DS
The abrasive separator makes the abrasive free
from contamination. The abrasive separator holds the
abrasive and supplies the blastwheel with abrasive.
15
