Salicru EQUINOX EQX2 4002-HT Manual De Usuario página 77

Idiomas disponibles

Idiomas disponibles

Fig. 47. Inserting the DC cable into the battery connector.
Push the battery connector up to the threaded joint and use an
5.
open-end spanner to firmly lock the connector with a torque
of 2 Nm, as shown in Fig. 48.
Fig. 48. Locking the connector.
1. Before carrying out the connection, make sure
that the polarity of the cable is correct.
Warning
2. Use a multimeter to measure the voltage of
the battery pack and make sure that the voltage
is within the inverter limits and that the polarity
is correct.
Insert the positive and negative connectors into the respec-
6.
tive inverter battery terminals. A "click" will ensure correct
assembly, as shown in Fig. 49.
Fig. 49. Connecting the battery.
To connect the battery system, optional equipment must
be purchased. If purchasing SALICRU batteries, see the
EL236*50 manual, otherwise, refer to the manufacturer's
manual.
USER MANUAL
5.3.4.3. Steps for the connection of
communications between battery
system and inverter.
The communications cable required for the battery system
is connected to the inverter at the factory. It is identified
as "BMS".
If you have accidentally disconnected it or need to connect
a  longer one, etc., unscrew the protective casing, pass it
through the cable gland that is labelled BMS and connect it to
the RJ45 port labelled with the same name.
Fig. 50. Identification of the RJ45 port on the inverter.
Connect the other end of the cable, identified as BMS, to the
communications port on the battery system. In the case of
the SALICRU battery system, it must be connected to the
"Inverter com" port of the BMS, as shown in the figure below.
Fig. 51. Connecting the inverter communications to the SALICRU
battery system.
5.3.5. AC ON-GRID and AC BACK-UP output
connection.
Before connecting to the grid, make sure that the voltage and
frequency of the grid meet the inverter's requirements. Please
refer to the technical parameters for more details.
This inverter includes a built-in residual current device (RCD).
If an external residual current device (RCD) is used, a type A device
must be used, with a trip current of 30 mA or more.
EQX2 SOLAR INVERTERS CONNECTED TO THE GRID
77
loading