Idiomas disponibles
Idiomas disponibles
7.4
Additional Letter Codes
Code
Condition
EC
External Control
Lo
Low Temperature Cutoff
bo
Boost
HH
High-High
JA
AquaLink
Jb
Boost (AquaLink RS Interface)
Section 8.
Temperature Conversion
To display Celsius or Fahrenheit on the digital display.
Pool Temp.
- Boost -
Salinity
or
Rate
Rate
Salinity
NOTE: The Boost mode will normally be activated if the Boost button D is depressed for 10 seconds. However, if
button D is held down an additional five (5) seconds (for the third beep), the state of the Boost mode will not
be changed.
|
Zodiac
Nature
2
Fusion soft
®
®
Reason
ORP unit or external controller has shut off chlorine production.
Temperature of Pool is < 50ºF (10°C). Chlorine production stopped.
In "Boost" mode unit will operate at 100% production for 24 run time hours.
Input has exceeded Maximum Range.
RS Online
AquaLink RS is controlling the Nature
®
percentages.
AquaLink RS is controlling the Nature
Press and hold button Pool Temp. -Boost- or D for 15 seconds
1.
(third beep).
Within five (5) seconds, momentarily press Salinity or C to enter
2.
the Fahrenheit/Celsius change mode.
3.
To toggle between Celsius and Fahrenheit, press Rate ↓ or Rate
↑, or A or B .
4.
Confirm by momentarily pressing Salinity or C . The change will
be stored in permanent memory.
Installation and Operation Manual
Page 43
ENGLISH
Fusion Soft and desired output
2
Fusion Soft and "Boost" is active.
2
