Idiomas disponibles
Idiomas disponibles
• DON'T List
•
Do not get fertilizer in your pool. Fertilizers contain nitrates which cause a high chlorine demand on pool water.
•
Never use dry acid to adjust pH in arid geographic areas with excessive evaporation and minimal dilution of pool
water with fresh water. A build up of by products can damage the electrolytic cell.
•
Do not add chemicals or salt to the pool unless the chlorinator is turned off.
•
For outdoor pools only, do not let chlorine stabilizer (cyanuric acid) drop below 10 ppm.
•
Do not add salt without first checking the pool salinity level. Too much salt can disable and possibly damage the
chlorinator.
Section 6.
User Maintenance Instructions
The following information describes how to care for your sanitizing system.
IMPORTANT Always test the chlorine levels of your pool before each use.
6.1
Daily
1.
Filtration and Circulation. Follow the manufacturer's directions for keeping the circulating pump
in good working order and operate it at least six (6) hours a day. Consult your Nature
times. Check pool filter periodically, clean as recommended by manufacturer.
6.2
Weekly
1.
Chlorine Test. Maintain ideal range by adjusting the Nature
5.4, Startup. Recommended Free Chlorine is 0.5 - 1 ppm.
Use a home test kit or ask your qualified service representative to test your water. It is recommended that
chlorine test samples be taken from two (2) places, described below. Compare the two (2) samples. A higher
level should be found at the pool return line. The higher level at the pool return line indicates the saltwater
chlorinator system is producing chlorine.
a.
At the pool return line.
b.
18" (46 cm) below the surface and well away from the pool return line.
2.
pH Level Test. Test the pH level of your pool with a test kit. If necessary, adjust according to your qualified
service representative's recommendations. APSP standard of 7.4 - 7.6 is recommended.
Never use dry acid to adjust pH in arid geographic areas with excessive evaporation and minimal dilution of pool
water with fresh water. A build up of by products can damage the electrolytic cell.
6.3
Monthly
Salt Level Test. Test pool water salt level by depressing the Salinity button C and reading the LCD located on
1.
the DuoLink
power centre user interface. Maintain the ideal range of 3.0 - 3.5 gpl for optimum performance. If
®
additional salt is required, follow the procedures and charts described in Section 4. If salt level does not rise after
24 hours, see Section 7, Troubleshooting.
Pool Water Sample. Take water sample to local pool store for testing.
2.
3.
Total Alkalinity Test. Test pool water for total alkalinity with a test kit. Adjust according to your qualified
service representative's recommendations. 80 - 120 ppm APSP Standard.
|
Zodiac
Nature
2
Fusion soft
Installation and Operation Manual
®
®
Fusion Soft chlorine production rate using Section
2
CAUTION
Page 35
ENGLISH
dealer for optimum run
2
