Idiomas disponibles
Idiomas disponibles
11. Secure the workpiece
– Use the clamping devices or a vice to hold the
workpiece in place. In this manner, it is held more
securely than with your hand.
– An additional support is necessary for long work-
pieces (table, trestle, etc.) in order to prevent the
machine from tipping over.
– Always press the workpiece firmly against the
working plate and stop in order to prevent bounc-
ing and twisting of the workpiece.
12. Avoid abnormal posture
– Make sure that you have secure footing and al-
ways maintain your balance.
– Avoid awkward hand positions in which a sudden
slip could cause one or both hands to come into
contact with the saw blade.
13. Take care of your tools
– Keep cutting tools sharp and clean in order to be
able to work better and more safely.
– Follow the instructions for lubrication and for tool
replacement.
– Check the connection cable of the electric tool reg-
ularly and have it replaced by a recognised spe-
cialist when damaged.
– Check extension cables regularly and replace
them when damaged.
– Keep the handle dry, clean and free of oil and
grease.
14. Pull the plug out of the outlet
– Never remove loose splinters, chips or jammed
wood pieces from the running saw blade.
– During non-use of the electric tool or prior to main-
tenance and when replacing tools such as saw
blades, bits, milling heads.
– When the saw blade is blocked due to abnormal
feed force during cutting, turn the machine off and
disconnect it from power supply. Remove the work
piece and ensure that the saw blade runs free.
Turn the machine on and start new cutting opera-
tion with reduced feed force.
15. Do not leave a tool key inserted
– Before switching on, make sure that keys and ad-
justing tools are removed.
16. Avoid inadvertent starting
– Make sure that the switch is switched off when
plugging the plug into an outlet.
17. Use extension cables for outdoors
– Only use approved and appropriately identified ex-
tension cables for use outdoors.
– Only use cable reels in the unrolled state.
18. Remain attentive
– Pay attention to what you are doing. Remain sen-
sible when working. Do not use the electric tool
when you are distracted.
19. Check the electric tool for potential damage
– Protective devices and other parts must be care-
fully inspected to ensure that they are fault-free
and function as intended prior to continued use of
the electric tool.
– Check whether the moving parts function fault-
lessly and do not jam or whether parts are dam-
aged. All parts must be correctly mounted and all
conditions must be fulfilled to ensure fault-free op-
eration of the electric tool.
– The moving protective hood may not be fixed in the
open position.
– Damaged protective devices and parts must be
properly repaired or replaced by a recognised
workshop, insofar as nothing different is specified
in the operating manual.
– Damaged switches must be replaced at a custom-
er service workshop.
– Do not use any faulty or damaged connection ca-
bles.
– Do not use any electric tool on which the switch
cannot be switched on and off.
20. Attention!
–
The use of other insertion tools and other ac-
cessories can entail a risk of injury.
21. Have your electric tool repaired by a qualified elec-
trician
– This electric tool conforms to the applicable safety
regulations. Repairs may only be performed by an
electrician using original spare parts. Otherwise
accidents can occur.
22. Do not use the cable for purposes for which it is
not intended Do not use the cable to pull the plug
out of the outlet. Protect the cable from heat, oil
and sharp edges.
Warning! This electric tool generates an electromag-
netic field during operation. This field can impair active
or passive medical implants under certain conditions.
In order to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the electric tool.
www.scheppach.com
GB | 23
