Idiomas disponibles
Idiomas disponibles
Height adjustment of the tool support
1.
Loosen the screw (2a) on the lower part of the tool
support (2b).
2.
Set the desired height.
3.
Fix the tool support (2) by tightening the screw (2a).
Switching on/off (fig. 1)
1.
Connect the device to the mains voltage.
2.
Switching on: Press the On switch (10) to switch
the device on.
3.
Switching off: To switch the device off, press the
Off switch (11) again.
m ATTENTION!
If you leave the device unattended or have finished
working, pull out the mains plug.
11. Working instructions
• Before you start working, read up on the subject in
detail in technical literature.
• When selecting your workpiece, look out for knots,
knotholes, cracks or similar. You could lose control
of your tool, which could result in serious injury.
Cracked workpieces can rupture during turning.
There is a danger of injury!
• Always cut the workpiece into shape as much as
possible before machining.
• Observe the maximum workpiece length and the
maximum workpiece diameter! You will find these in
the technical data.
• The workpiece must be fixed in the centre, an un-
balanced workpiece will affect the service life of the
machine.
• Only use tools suitable for turning.
• Never stand in the trajectory of the workpiece.
• Before starting work, with the mains plug removed,
check the following by turning manually:
- Is the workpiece stuck?
- Does the workpiece come into contact with the
tool support?
• Always start with a lower speed and increase it grad-
ually.
• Do not apply the tool to the workpiece until it has
reached the set rotational speed.
Remove blockages
Switch the device off and pull out the mains plug.
Clean the device of dust and chippings to remove the
blockage.
28 | GB
12. Electrical connection
The electrical motor installed is connected and ready
for operation. The connection complies with the appli-
cable VDE and DIN provisions. The customer's mains
connection as well as the extension cable used must
also comply with these regulations.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables with the designation H05VV-F.
The printing of the type designation on the connection
cable is mandatory.
AC motor
• The mains voltage must be 230 V~.
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm2.
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate
www.scheppach.com
