Metabo W 6-100 Instrucciones De Manejo página 17

- Direct the nose (12) of the clamping ring towards
the recess (11) on the flange and then
- push the safety guard (6) onto the flange.
- Turn the safety guard until the closed section is
facing the operator.
- Tighten the clamping screw (10) firmly. Make
sure that the guard is seated securely - you
should not be able to turn the safety guard (6).
7 Attaching the grinding
wheel
Disconnect the mains plug before changing
any accessories. The machine must be
switched off and the spindle at a standstill.
For reasons of safety, attach the parting
guard before performing parting work (see
chapter 10 Accessories).
7.1 Locking the spindle
- Press in the spindle locking button (3) and turn
the spindle (2) by hand until the spindle locking
button engages.
7.2 Placing the grinding wheel in position
1
1
- Place the supporting flange (1) on the spindle
(see illustration above). The flange should not
turn on the spindle when properly attached.
- Place the grinding wheel on the support flange
(1) (see illustration above).
The grinding wheel must lay flat on the
supporting flange. The metal flange on the
parting grinder disc must lay flat on the support
flange.
7.3 Securing/Releasing the clamping nut
Securing the clamping nut (7):
The 2 sides of the clamping nut are different.
Screw the clamping nut onto the spindle as
follows:
A
7
B
7
- A) For thin grinding wheels:
The edge of the clamping nut (7) faces upwards
so that the thin grinding wheel can be attached
securely.
B) For thick grinding wheels:
The edge of the clamping nut (7) faces down-
wards so that the clamping nut can be attached
securely to the spindle.
- Lock the spindle. Turn the clamping nut (7)
clockwise using the 2-hole spanner (8) to
secure.
Releasing the clamping nut:
- Lock the spindle (see chapter 7.1). Turn the
clamping nut (7) anticlockwise using the 2-hole
spanner (8) to unscrew.
8 Use
8.1 Switching On and Off
Always guide the machine with both hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw in
additional dust and shavings. When
switching the machine on and off, keep it away
from dust deposits. After switching off the
machine, only place it down when the motor has
come to a standstill.
Avoid inadvertent starts: always switch the
tool off when the plug is removed from the
mains socket or if there has been a power cut.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand in a
safe position and concentrate.
Slide switch:
ENGLISH
ENG
0
I I
17