Idiomas disponibles
Idiomas disponibles
Malfunction
Error message 'E-02' or 'E-
03'
Error message 'E-04'
Error message 'E-05'
Error message 'E-72'
Error message 'E-99'
9.2
Troubleshooting table
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault
Laser beam not working.
The laser beam flashes.
Inclination adjustment not
working.
Beam position cannot be
adjusted.
Remote control unit not work-
ing.
*2354475*
Possible cause
Fault in the internal measuring sys-
tem.
The angle is not measured cor-
rectly.
The positioning of the laser is not
set correctly.
Excessive inclination of the laser
during the calibration check or
adjustment.
Fault in the internal memory
Possible cause
Battery charge state too low
The laser beam has been switched
off by means of the remote control
unit.
If the inclination warning appears
on the display, the laser was tilted
to an excessive angle of inclina-
tion.
The laser was bumped or is af-
fected by strong vibrations.
The laser is in locked mode.
The value set is outside the possi-
ble range.
If the inclination warning appears
on the display, the laser was tilted
to an excessive angle of inclina-
tion.
Battery charge state too low
The laser is in locked mode.
The value set is outside the possi-
ble range.
The laser is in locked mode.
The batteries of the remote control
unit are discharged.
2354475
Action to be taken
▶ Switch the product off and then
on again.
▶ Severe vibrations in the vicinity
of the laser might be responsi-
ble. Eliminate the vibrations.
▶ Consult Hilti Service.
▶ Switch the product off and then
on again.
▶ Switch the product off and then
on again.
▶ Level the laser correctly and re-
peat the checking and adjusting
procedure.
▶ Switch the product off and then
on again.
Action to be taken
▶ Charge the battery.
▶ Switch the laser beam on again.
▶ Position the laser closer to the
horizontal until the message is
no longer displayed.
▶ Eliminate the cause of the
disruption.
▶ Press the SET
button to
cancel locked mode.
▶ Do not exceed the maximum
possible range for adjustment
(see technical data).
▶ Position the laser closer to the
horizontal until the message is
no longer displayed.
▶ Charge the battery.
▶ Press the SET
button to
cancel locked mode.
▶ Do not exceed the maximum
possible range for adjustment
(see technical data).
▶ Press the SET
button to
cancel locked mode.
▶ Replace the batteries.
English
31
