Idiomas disponibles
Idiomas disponibles
MN006348A01-AE
Chapter 1 : IMPRES Batteries and Chargers
Status
Fault
Standby
End of Service Life
Recalibration
1.3
IMPRES Battery Initialization
For a full IMPRES functionality, a new IMPRES battery must be initialized by the charger.
The charger automatically detects the new IMPRES battery, and automatically starts initialization.
Initialization is the first calibration and reconditioning of an IMPRES battery.
Phases of Battery Initialization
The first phase is a battery discharge, indicated by a steady amber LED. The second phase is a full
charge, indicated by a steady green LED. Refer to
NOTE: This process may take up to 12 hours or more to complete, depending on the state of
charge and capacity of the battery. Interruption of either phase delays initialization until the next
charging opportunity.
1.4
IMPRES Pocket-to-Pocket
When charging IMPRES batteries, the IMPRES charger records charging information in the battery
memory.
Charging can resume if the user remove IMPRES battery from one IMPRES charger pocket and within
30 minutes, insert it into the same or a different IMPRES charger pocket.
1.5
Automatic IMPRES Calibration and Recondition
The IMPRES charger automatically assesses the condition of an IMPRES battery.
Based on the condition, the charger automatically calibrates and reconditions the battery. This process
starts with battery discharge, indicated by a steady amber LED status. Calibration and recondition
are complete only after a full charge, indicated by a steady green LED status. See
Charging Indicators on page
12
LED Indicator
Blinking Red
Blinking Amber
Alternating red and green
Alternating amber and green
IMPRES Battery Charging Indicators on page
11.
Description
Not chargeable; remove and
re-insert radio or battery.
•
Battery is waiting to rapid
charge.
•
Battery may be too hot, too
cold, or low voltage.
•
Charger may be too hot.
Battery remains usable but
may be nearing the end of its
rated service life.
Battery requires calibration or
battery is due for calibration.
IMPRES Battery
11.
