Stahlwille Manoskop 730N Instrucciones De Utilizacion página 45

3. Turn the Allen key with great care and
very slowly. Turning in a clockwise
direction increases the cut-out torque
level, turning in the other direction
decreases it. The screws will lock in
any position.
4. Once you have made an adjustment
using one screw, check the effect by
testing the cut-out value on the torque
tester.
5. Repeat the adjustment of one or both
screws and the testing process until
the deviation has been compensated.
6. Finally, do a thorough test again.
Proceed as described under
„Checking the accuracy of the cut-out
value".
ã
C AUTI O N!
Important! If you cannot
compensate for the
deviation within the
prescribed tolerances
using the method
described here, it is
likely that the cut-out
mechanism is damaged.
Such defects can only be
repaired if the torque
wrench is dismantled.
Contact STAHLWILLE in
such cases.
45