Stahlwille Manoskop 730N Instrucciones De Utilizacion página 41

Checking the accuracy of
the cut-out value
A torque tester of sufficient capacity and
accuracy is required for the inspection.
If you have access to such a tester, you
may inspect the Manoskop
Suitable torque testers are available from
STAHLWILLE. It is also possible for
STAHLWILLE to test the Manoskop
you.
Here, we demonstrate the inspection
using the Manoskop
To carry out the test, proceed as follows:
1. Set the torque wrench to the highest
scale reading
2. Operate the torque wrench five times
ensuring it cuts out properly each time
Important note on the accuracy of the
readings:
3. Set the torque wrench to 20% of the
maximum scale reading.
ã
C AUTI O N !
Once the wrench has cut
out, never apply more
pressure! You should
therefore not pull too
fast in case you cannot
stop the motion quickly
enough when you hear
the click.
®
®
730N/10.
yourself.
®
for
41