Idiomas disponibles
Idiomas disponibles
authorized service center.
Light
ON/OFF
Red on
Green on
2. INSTALLING AND REMOVING THE
BATTERY PACK (SEE FIG. B)
a) TO REMOVE THE BATTERY PACK
Depress the Battery Pack Release Button firmly first and
then slide the Battery Pack out from your tool.
b) TO INSTALL THE BATTERY PACK
Slide the fully charged Battery Pack onto the tool with
sufficient force until it clicks into position.
3. ON / OFF SWITCH (SEE FIG. C)
Depress the On/Off switch (b) to start and release it to stop
your drill.
The on/off switch (b) is fitted with a brake function which
stops your chuck immediately when you quickly release the
switch.
It is also a variable speed switch that delivers higher speed
and torque with increased trigger pressure. Speed is
controlled by the amount of switch trigger depression.
WARNING: Do not operate for long
periods at low speed because excess
heat will be produced internally.
4. SWITCH LOCK (SEE FIG. C)
The switch trigger can be locked in the OFF position. This
helps to reduce the possibility of accidental starting when
not in use. To lock the switch trigger, place the rotation
control (a) in the center position.
5. REVERSIBLE (SEE FIG. C)
For drilling and screw driving use forward rotation marked
"
" (rotation control (a) is moved to the left). Only use
reverse rotation marked "
moved to the right) to remove screws or release a jammed
drill bit.
WARNING: Never change the direction
of rotation when the chuck is rotating,
wait until it has stopped!
6. TWO-SPEED GEAR CONTROL (SEE FIG. C)
The drill has a two-speed gear control (c) designed for
drilling or driving at LO (mark is 1) or HI (mark is 2) speeds.
A slide switch is located on top of the drill to select either LO
18
Status
Charging
Fully Charged
" (rotation control (a) is
or HI speed. When using the drill in the LO speed range, the
speed will decrease and the drill will have greater power and
torque. When using the drill in the HI speed range, the speed
will increase and the drill will have less power and torque.
GEAR I
Low speed range: for screwdriving or working with large
drilling diameter
GEAR II
High speed range: for working with small drilling diameter
WARNING: To prevent gear damage,
always allow the chuck to come to a
complete stop before changing the direction
of rotation or the two-speed gear control.
7. AUTOMATIC SPINDLE LOCK
The automatic spindle lock allows you to use it as a regular
screwdriver. You can give an extra twist to firmly tighten a
screw, loosen a very tight screw or continue working when
the battery energy has expired. For manual screwdriver
purposes, the chuck is automatically locked when the tool
is off.
8. CHUCK ADJUSTMENT (SEE FIG. D)
To open the chuck jaws rotate the front section of the
chuck. Insert the drill bit between the chuck jaws and rotate
the front section in the opposite direction. Ensure the drill bit
is in the center of the chuck jaws. Finally, firmly rotate the
front chuck section in the opposite directions. Your drill bit is
now clamped in the chuck.
9. TORQUE ADJUSTMENT (SEE FIG. E)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment
ring. The torque is greater when the torque adjustment ring
is set on a higher setting. The torque is less when the torque
adjustment ring is set on a lower setting.
When drilling in masonry and concrete choose the hammer
position.
When drilling in wood, metal, plastic and screwdriver
choose the drill position.
Make the setting as follows:
1 - 4
driving small screws
5 - 9
for driving screws into soft material
10 - 18
for driving screws into soft and hard material
15 - 20
for driving screws into hard wood
21
for driving larger screws
for heavy drilling
for drilling in masonry
EN
