Idiomas disponibles
Idiomas disponibles
Points in replacement of engine oil
Ne er discard replaced engine oil in garbage, earth or sewage ditch. isposal o oil is regulated by law. n disposal, always ollow the rele ant
laws and regulations. or any points remaining unknown, contact Authori ed Ser ice Agent.
il will deteriorate e en when it is kept unused. er orm inspection and replacement at regular inter als replace with new oil e ery 6 months .
Cleaning of air cleaner
WARNING: N
AMMAB ES S
nter al o Cleaning and nspection
1. oosen the knob bolt 1 .
2. emo e the air cleaner co er 2 .
3. ake out the element 3 and remo e any dirt with the brush.
NOTE:
he element is a dry type and should not get wet. Ne er wash with water.
4. eplace the element with a new one i it is damaged or ery dirty.
5.
ipe o any oil that has come into contact with the breather with a rag or cloth.
6. nstall the element in the cleaner case 4 .
7. Attach the air cleaner co er and tighten the knob bolt.
DANGER:
Clean the element se eral times a day, i e cessi e dust adheres to it.
operation continues with the element remaining not cleared o oil, oil in the air cleaner may all outside, resulting in oil contamination.
Checking the spark plug
CAUTION:
hen remo ing the spark plug, clean the spark plug and cylinder head rst, so that no dirt, sand, etc. will enter the cylinder.
ou must remo e the spark plug a ter the engine has cooled down in order to a oid damaging the threaded hole in the cylinder.
he spark plug must be installed properly into the threaded hole.
1. pening closing the plug co er
o open the plug co er, pull up on the seam o the plug co er projection and slide
in the direction o the
EN indication as shown in the gure at right.
hen closing the co er, slide the co er in the C
the plug co er projection rides o er the engine co er. inally, push in the projection.
2. emo ing the spark plug
se an attached bo wrench to remo e or install the spark plug.
3. Checking the spark plug
he clearance between two electrodes o spark plug
0.7 to 0.8 mm. Adjust to the correct clearance when it is too wide or too narrow.
Clean thoroughly or replace the spark plug i it has accumulated carbon or
contaminated.
4. eplacing the spark plug
or replacement, use N K-CM 6A.
C
B E
aily e ery 10 operating hours
SE direction till the click under
see the
installed at an angle, the threaded hole in the cylinder will get damaged.
gure
is
24
( )
( )
( )
(1)
0.7
0.8 mm
