Idiomas disponibles
Idiomas disponibles
Cleaning the tube joint
WARNING:
o not remo e the hose band, tube, or cap, when the solution discharge le er is
open.
o not loosen the cap when the solution discharge le er is open.
1. oosen and remo e the cap 1 that comes out with the strainer 2 .
2. Clear dust and particles away rom strainer.
3. ut the strainer back to the original position. Be sure to tighten the cap rmly.
INSPECTION AND MAINTENANCE
DANGER:
Be ore inspection and maintenance, stop the engine and allow it to cool. emo e also the spark plug and plug cap.
inspection or maintenance is attempted immediately a ter engine stop or with the plug cap le t attached, the operator may su er burn or an
accident due to careless startup.
A ter inspection and maintenance, make sure that all parts are assembled. hen, proceed to operation.
Always wear rubber chemical-resistant glo es or inspection and maintenance.
NOTICE:
Ne er use gasoline, ben ine, thinner, alcohol or the like. iscoloration, de ormation or cracks may result.
Replacement of engine oil
eteriorated engine oil will shorten the li e o the sliding and rotating parts to a great e tent. Be sure to check the period and uantity o replacement.
DANGER:
n general, the engine main unit and engine oil still remain hot just a ter the engine is stopped. n replacement o oil, make sure that the engine
main unit and engine oil are su ciently cooled down.
the oil may not return to crank case. o not check the oil le el right a ter engine stops.
the oil lled abo e the limit, it may be contaminated or may catch re with white smoke.
Interval of replacement: nitially, e ery 20 operating hours, and subse uently e ery 50 operating hours
Recommended oil: SAE10 -30 oil o A
Oil change procedure
1. Set the mist blower down on a le el sur ace.
2. lace a waste oil container under the drainage hole 1 to catch the oil as it drains out.
he container should ha e a capacity o at least 220 m to be able to catch all o the oil.
3. oosen the oil drain bolt 2 to let the oil drain out. Be care ul not to allow oil to get on the
uel tank or other parts.
CAUTION:
Be care ul not to lose the gasket aluminum washer 3 . lace the oil drain bolt 2 in a
location where it will not accumulate dirt.
4. emo e the oil cap 4 .
CAUTION:
Be sure to set the oil cap 4 down in a location where it will not accumulate dirt.
5. As the le el o the oil being drained decreases, tilt the mist blower o er on to the side with the drain so that the oil will completely drain out.
6. A ter the oil has completely drained out, tighten the oil drain bolt 2 securely.
CAUTION:
o not orget to put the gasket aluminum washer 3 back on when reattaching the drain plug.
7. Adding oil during the oil change procedure is per ormed in the same manner as the separately e plained procedure or adding oil whene er the
le el is insu cient. Always add oil by lling rom the opening under the oil cap.
Speci ed oil le el Appro imately 220 m
8. A ter lling with oil, tighten the oil cap 4 securely to pre ent oil leaks.
Classi cation S Class or higher 4-stroke engine oil or automobile
emo ing the oil cap 4 allows the oil to drain easily.
therwise, there may remain a risk o burn. n addition just a ter o the engine stops all
the bolt is not tightly astened, this may result in an oil leak.
23
(1)
( )
( )
( )
(1)
( )
