Idiomas disponibles
Idiomas disponibles
STARTING AND STOPPING ENGINE
1. Starting
WARNING:
Ne er attempt engine start in a place where the unit was re ueled.
therwise, it may cause ignition or re.
E haust gas rom the engine is to ic. o not operate the engine in a poorly- entilated place, such as in a tunnel, building, etc.
perating the engine in the poorly- entilated place may cause poisoning by e haust gas.
n case o detection o any abnormality in sound, odor, ibration a ter start, stop the engine immediately and carry out inspection.
the engine is operated without attending such abnormality, an accident may occur.
Make sure that the engine stops when the stop control le er is set to
Make sure that the solution discharge le er is closed be ore starting the machine.
1) When the engine is cold, or after refuelled (cold start):
1
Set this machine on a at space.
2
Set the stop control le er 1 to
3
ush the primer pump 2 se eral times until uel enters into the primer
pump.
n general, uel enters into the carburetor by 7 to 10 pushes.
the primer pump is pushed e cessi ely, an e cess o gasoline returns
to the uel tank.
4
i t the choke le er 3 .
5
old the air cleaner co er with a le t hand to pre ent the engine rom
mo ing, settle down to take the stable position.
6
ull the starter handle slowly until eeling compression.
strongly. t may take two to our attempts until engine starts.
o not pull the rope to the ull e tension.
eturn the starter handle gently into the housing.
starter handle may hit your body or it may not rewind appropriately.
7
hen the engine starts, gradually lower the choke le er while checking
the engine operation. Be sure to lower the choke le er ully in the end.
n cold or when the engine is cooled down, always lower the choke
le er slowly.
therwise, the engine may stop.
8
rasp the control handle the lock-o le er is released by the grasp
and pull the throttle trigger or warm-up operation. Continue warm-up
operation or 2 to 3 minutes.
hen the rotation o the engine stabili es and the engine accelerates
smoothly rom low to high speed by throttle mo ement, it is completion o
warming-up.
hen starting the engine, keep a distance o at least 3 m 10 eet .
position.
hen pull it
therwise released
15
position.
(1)
( )
( )
