Idiomas disponibles
Idiomas disponibles
10 mm
min
When installing an oven under the hob,
separator must not be put and the minimum
distance between the bottom part of the hob
and the oven must not be lower than 10 mm.
Do not install not cooled oven under this hob
and install the oven following its own installation
requirements.
Bottom
A watertight seal gasket is supplied with the
hob. Fit the seal gasket around the bottom hob
as described and make sure that it is properly
fitted to avoid any leakage into the supporting
furniture.
Normal Fixing:
- Get the fixing
clips from
accessory bag
and screw them
into the position
shown on
bottom box. (Do
not tighten the
screws to block
clips, they should move freely)
- Insert the hob in center position of cut out.
- Turn the clips and tighten them fully.
Quick Fixing:
(Depending on
model)
Get four springs form
accesory bag and
screw them onto
bottom box as shown
in figure.
Center and insert the hob.
Press the sides of hob until it is supported
around its entire perimeter.
FLUSH
INSTALLATION
After checking
that the
position of the
hob is correct
fill the gap
between the
worktop and
the hob with
silicone adhesive. Flatten the silicone layer with
a scraper or with wet finger damped with water
and soap before it forms.
Do not use the hob until the silicone layer it is
completely dry.
GB 58
