Idiomas disponibles
Idiomas disponibles
INSTALLATION & OPERATION
5.
Cement as many couplings and sections
of rigid PVC pipe on both the pressure
and suction sides as it takes to equal the
operating depth, then firmly clamp the
assembly with a pipe clamp to prevent
the assembly from sliding down into the
well.
6.
Remove pipe clamp and slide well seal
over PVC pipes and onto well casing.
DO NOT let assembly slide down
into well. Position assembly so that
twelve inches of PVC pipes protrude
from well seal. Alternately, turn bolts
on well seal clockwise until rubber
gaskets are tight against the well
casing and the PVC pipes.
7.
Cut 1" pipe 2" shorter than the
1-1/4" pipe. Smooth rough
edges. Cement 1" and 1-1/4"
PVC elbows to pipes protruding from
the well seal.
8.
Thread a 1-1/4" male PVC adapter into
top hole in front of pump. Thread 1"
x 4" nipple into bottom hole in front
of pump. Thread the 1" female PVC
adapter onto the 1" x 4" nipple.
10
9.
Cement
as many
sections and
couplings of
rigid 1" and
1-1/4" PVC as
needed to
connect the 1" female PVC adapter and the 1-1/4" male PVC
adapter to the 1" and 1-1/4" PVC elbows.
10. Prime pump as described in Priming the Pump.
11. Open pressure regulator kit. Apply 2-3 wraps of PTFE pipe
thread sealant tape tape to the
male threads on the body of the
pressure regulator. With pipe
wrench, thread the pressure
regulator into 1" discharge at top
12" OF
7168 0117
of pump. Thread pressure gauge
PVC PIPE
into side of pump case.
PROTRUD-
ING FROM
WELL
SEAL
12. Thread plug into opening to right of
pressure regulator outlet.
WELL SEAL
13. Complete all electrical connections as described in
7169 0117
1-1/4" PVC
Wiring Your Pump.
ELBOW
1" PVC
14. Thread 3/4" male PVC adapter into
ELBOW
pressure regulator outlet.
1" PIPE 2"
SHORTER
THAN 1-1/4"
PIPE
15. Thread tank tee into
pre-charged pressure tank. Plug
7170 0117
two outlets on tank tee with two
1-1/4" MALE
1/4" plugs.
PVC ADAPTER
1" FEMALE
PVC
ADAPTER
1" x 4"
NIPPLE
16. Thread boiler drain into front of
tank tee. Thread 3/4" male PVC
7171 0117
adapter into inlet side of tank tee.
Connect household plumbing to
other side of tank tee.
1-1/4" PVC PIPE
1" PVC PIPE
FEMALE ADAPTER
PRESSURE
REGULATOR
7172 0117
PRESSURE
REGULATOR
OUTLET
PLUG
7173 0117
3/4" MALE
PVC ADAPTER
7174 0117
1/4" PLUGS
TANK TEE
7175 0117
3/4" MALE
PVC
ADAPTER
1/2" BOILER
DRAIN
7176 0117
FP1002 (02-01-2023)
