Power Management Function; Playing A Record; Turntable Operation - 1byone Audio-Technica AT3600 Manual Del Usuario

Main Power Connection
EN
1. Insert the DC plug of the AC adapter cord into the DC INPUT Jack at the back of the
DE
turntable.
2. Plug the AC adapter into a normal power outlet.
FR
NOTE: Do not plug the AC power adapter into a power outlet before all turntable
ES
assembly is completed. Before turning on turntable power, recheck all connections to
IT
make sure they are correct and secure. Always turn off the turntable before connecting
or disconnecting from power.

Power Management Function

The turntable will automatically go into standby mode after 20 minutes of inactivity.
The indicator light will turn off.
To resume operation, press and hold the START button for 3 seconds.

Playing a Record

1. Before playing a record
1.1 Pull the protector straight forward to remove
it.
NOTE: Applying a downward force may cause
the stylus to come off the body. Only low
volume is outputted if the stylus has come off,
or is about to come off, so refer to "Replacing
the stylus" to reattach the stylus correctly.
1.2 Place the record on the felt mat so that the center hole aligns with the spindle.
Protector
10

2. Turntable Operation

Sufficiently lower the volume of the amplifier and speakers first.
2.1 Connect the included power adapter to the turntable, press and hold the START
button for 3 seconds. The turntable will turn on. The indicator light will turn red.
2.2 Remove the stylus protector from the stylus.
2.3 Place the record on the slip mat.
2.4 Rotate the function knob to switch between 33 and 45 RPM speeds according to
the type of record.
2.5 Press the START button once and the platter will play or pause.
2.6 Unlock the tonearm clip and set the tonearm lift lever to the up position.
2.7 Position the tonearm over the desired location (groove) on the record.
2.8 Carefully lower the tonearm on the record.
2.9 Turn up the volume of the turntable as needed.
2.10 When you are finished playing the record, raise the tonearm, return it to rest on
the arm clip and long press the START button to turn off the turntable.
NOTE:
1. If the silent pause time between each track is longer than 3 minutes, the platter
will stop spinning automatically to avoid damaging the record. The indicator light
will turn red. To resume operation, press the START button.
2. If the felt mat gets dirty, it can easily scratch the record, so remove the felt mat
periodically and wipe off any dust.
3. To prevent the record from getting scratched and warping, remove it after use.
4. Do not use a disk stabilizer.
11
EN
DE
FR
ES
IT