Installation Instructions - V-TAC 80133970 Instrucciones De Instalación

INSTALLATION INSTRUCTIONS

NOTE: Jumper cap switching position has the functions of AC/DC (Maintained) and DC
(non-maintained). P1 is AC/DC position, P2 is DC position. (Refer to Picture F)
THREE INSTALLATION METHODS
WALL MOUNTING
I SURFACE MOUNTING (For wall only):
1. Switch off the main power before installation
2. Open the emergency light with a help of a screwdriver (Figure A).
3. Insert the Lead wires from the wall through the hole base cover as shown in (Figure B).
4. Install the base cover on the wall with the help of screws.
5. For connecting the wires, pull out the connector from the front cover, unscrew the
screws on them and connect the lead wires to PCB AC and green terminal.
6. Put back the connector on the front cover.
7. Place back the front cover on the base
8. Switch on the main power
FLUSH MOUNTING
ENGLISH
CEILING MOUNTING