Product Characteristics - YATO YT-82562 Manual Original

PRODUCT CHARACTERISTICS

The paint sprayer is an electrical device used for covering the surface with a coating material or lacquer. The unit does not require
power from an external source of compressed air, the coating material is pumped from the unit to the gun using a fl exible hose.
The long hose connecting the gun to the unit allows universal use of the product. The unit is equipped with a pump that sucks the
paint from any tank itself. The correct, reliable, and safe operation of the tool depends on its proper use, therefore:
Read and keep the entire manual before the fi rst use of the device.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
specifi ed in this manual.
EQUIPMENT
The packaging should include: paint sprayer, spray gun, hose connecting the gun to the unit.
TECHNICAL PARAMETERS
Parameter
Catalogue No.
Mains voltage
Mains frequency
Rated power
IEC protection class
Weight
Maximum pressure
Rated capacity
Coating material temperature
Hose length: gun-unit
Noise level
pressure L
pA
power L
wA
Vibration level a
h
Protection rating
SAFETY INSTRUCTIONS
Always observe the safety instructions in the instructions manual as well as the other OHS guidelines when using the product.
The product must not be used by children or by persons not trained in its use.
The device has not been designed for use in potentially explosive atmospheres and it is not allowed to use it in such environments.
The device can only be used to spray the following liquid coating materials: latex paints, acrylic paints for painting walls and ceil-
ings, as well as oil paints for painting steel structures and enamels and stains for painting wooden surfaces.
The device has not been designed for use of electrostatic spraying equipment. It is forbidden to use such equipment in this device
as it can cause a number of serious risks to operators.
Toxic gases, mists and vapours may form during the use of the device. Inhalation of such substances is a serious hazard for the
operator and persons present in the workplace, as well as in special conditions outside the workplace. Gases, mists and vapours
can be transferred with air and travel long distances. Therefore, proper and effi cient ventilation must always be provided at the
workplace. The operator and persons present in the workplace should wear respiratory protection and protective goggles. Before
starting spraying the coating material, read the information provided by its manufacturer and follow the instructions contained
therein.
The device does not have surfaces or parts within reach during normal operation, maintenance or repair, not normally in contact
with the human body, whose temperature may exceed 48°C or be lower than 0°C.
Pressurised coating materials or compressed air must not be directed at persons or animals.
Read and keep the entire instructions manual before starting work and keep it for future reference. In case of handing the device
over, provide the new user with the instructions manual. The operator should undergo training in terms of operating, setting,
cleaning and maintaining the device.
The device can only be positioned horizontally on a solid, level, and fl at surface. The device must not be suspended or held in the
hand during operation. The handle can only be used to transport the turned-off device.
Before connecting the device to the power supply, always check the rated voltage of the mains corresponds to the voltage indi-
cated on the product's rating plate. Always connect the device to a socket equipped with an earthing conductor. Connection to a
O R I G I N A L
GB
Unit
[V~]
[Hz]
[W]
[kg]
[MPa]
[l/min.]
[°C]
[m]
[dB(A)]
[dB(A)]
[m/s 2 ]
I N S T R U C T I O N S
Value
YT-82562
230
50
480
I
14.5
22.7
2.0
5 ~ 40
15
73.9 ± 3.0
81.0 ± 3.0
≤ 2.5
IP20
15