Product Characteristics - YATO YT-82550 Manual De Usuario

PRODUCT CHARACTERISTICS

Electric painting gun is an electric device of II insulation class designed for coating of surface with coating material or paint. Thanks
to integrated compressor the gun does not need any external compressed air supply. Capacious paint container combined with
high performance ensures the effi cient operation. Correct, reliable and safe operation of the product depends on proper operation,
therefore:
Before starting the work with this appliance, please read this manual and keep it properly.
The supplier does not assume any liability for damages resulting from failure to follow safety regulations and recommendations
specifi ed in this manual.
EQUIPMENT
The packaging should include a spray gun, paint container and viscometer.
TECHNICAL PARAMETERS
Parameter
Catalogue number
Mains voltage
Mains frequency
Rated power
Electrical protection class
Weight
Container capacity
Rated capacity
Nozzle diameter
Noise level
pressure L
pA
power L
WA
Vibration level a
h
Protection class
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The notion
of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters what-
soever in order to adapt the plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and
disconnect the plug from the mains socket. Avoid contact of the power supply cable with heat, oils, sharp tools and
moving elements. Damage to the power supply cable increases the risk of an electric shock.
In case work is realised outside closed areas, it is necessary to use extension cords designed for applications outside
closed areas. Using a correct extension cord permits to reduce the risk of an electric shock.
If operating a power tool in a damp location is unavoidable, use a residual current device (RDC) protected supply. Use of
an RCD reduces the risk of electric shock.
O R I G I N A L
10
GB
Measuring unit
[V]
[Hz]
[W]
[kg]
[l]
[l/min]
[mm]
[dB(A)]
[dB(A)]
[m/s ]
2
I N S T R U C T I O N S
Value
YT-82550
~230
50
500
II
1.4
1
0.4
1.8
102.0 ± 3.0
113.0 ± 3.0
2.12 ± 1.5
IPX0