Tabla de contenido
Idiomas disponibles
Idiomas disponibles
BEFORE YOU CALL
Self-Clean Problems
Problem
Self clean does not work.
Oven racks discolored or
do not slide easily.
Soil not completely re-
moved after self clean.
Other Problems
Problems
Appliance is not level.
Cannot move appliance
easily. Appliance must be
accessible for service.
Oven light does not work.
36
Cause / Solution
Oven control not set properly. See "Self Clean" on page 24.
Oven racks left in oven cavity during self clean. Remove oven racks from
oven cavity before starting a self-clean cycle. Clean by using a mild abrasive
cleaner following manufacturer's instructions. Rinse with clean water, dry, and
replace in oven.
Self clean was interrupted. Review instructions on "Self Clean" on page 24.
Excessive spills on oven bottom. Remove excessive spills before starting self
clean.
Failure to clean soil from the oven frame, the door liner outside the oven door
gasket, and the small area at the front center of the oven bottom. These ar-
eas are not in the self-cleaning area, but get hot enough to burn on residue.
Clean these areas before starting the self-cleaning cycle. Burned-on residue
can be cleaned with a stiff nylon brush and water or a nylon scrubber. Be
careful not to damage the oven gasket.
Cause / Solution
Poor installation. Place the oven rack in the center of the oven. Place a level
on the oven rack. Adjust the leveling legs at the base of the appliance until
the rack is level.
Kitchen cabinet alignment may make range appear not level. Be sure cabi-
nets are square and have sufficient room for appliance clearance.
Cabinets not square or are built in too tightly. Contact the builder or installer
to make the appliance accessible.
Be sure the oven light is secure in the socket. See "Replacing the Oven Light"
on page 32.
en
Tabla de contenido
