cecotec BOLERO AGUAZERO 1006 COMPACT Manual De Instrucciones página 65

supplied by the inlet must be at least 0.04 MPa and at most 1 MPa. If the pressure is over 1
MPa, you must install a pressure release valve to the inlet.
After connecting the water supply hose, open the tap completely and check if there is
any water leakage. Close the water supply tap after every washing programme.
Step 3: Drain hose connection
Fig. 5
- You can install the dishwasher following 3 different methods (A, B, C), either in a cabinet or
over a worktop. Connect the drain hose directly to a drain, over the sink or to an outlet with
at least a 4-cm diameter.
- If the end of the drain hose is free, it should not be immersed in water, to avoid water
backflow.
- If you need a drain hose extension, make sure you use a similar drain hose.
- The drain hose must be correctly placed to prevent water leakage.
- Make sure the drain hose is not twisted or crushed.
- The height of the drain pipe A must be higher than the sink edge height.
- Secure the pipe to the end of the drain hose.
IMPORTANT: if the sink is at a 1-m height from the floor, the excess water in the drains
cannot be directly drained in the sink. You will need to empty the remaining water from
the hoses in an exterior bucket or adequate container and lower than the sink.
IMPORTANT: utensils will not be washed correctly if you use a drain hose with over 4-m
length.
Step 4: Electric connection
- Connect the dishwasher to the electric circuit.
WARNING: make sure that the mains voltage matches the voltage stated on the rating
label of the appliance and that the wall outlet is grounded.
The dishwasher plug must be connected to a grounded socket. If you do not have
a grounded socket, a grounded installation must be carried out by a licensed
electrician. In case of ungrounded use, Cecotec shall not be liable for any
malfunction or damage that this may cause.
- Make sure there is an appropriate grounded socket before using the appliance.
Step 5: Placing the dishwasher
Fig. 6
- You must leave at least 5 mm between the upper part of the dishwasher and the cabinet,
and the exterior door must be aligned with the piece of furniture.
- The dishwasher must be placed near the water and drain hose, previously connected, and
the power supply.
- You must ensure enough space to open the door completely.
AGUAZERO 1006 COMPACT/SILVER
ENGLISH
65