Assembly - RIDGID R4093 Manual Del Operador

ASSEMBLY

UNPACKING
See Figures 6 - 7.
This product requires assembly.
 Carefully lift the parts from the carton and place on a level
work surface.
NOTE: Many of the loose parts are stored in the water
reservoir. The side water tray extension is located beneath
the polyfoam.
WARNING:
Do not use this product if any parts on the Loose
Parts List are already assembled to your prod-
uct when you unpack it. Parts on this list are not
assembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result
in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
 The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures ex-
plained in this manual.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not oper-
ate this tool until the parts are replaced. Use of this
product with damaged or missing parts could result
in serious personal injury.
WARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in acci-
dental starting and possible serious personal injury.
INSTALLING MOTOR HEAD ASSEMBLY TO
BASE
See Figure 8.
 Align the holes in the motor head assembly with the holes
on the base.
NOTE: The studs in the motor head assembly should be
in line with the center holes in the base.
 Lower the motor head assembly onto the base and push
the studs into the center holes.
 Thread cap screws through washers and motor head
assembly and into holes on base.
 Tighten screws using the 8 mm hex key (provided).
NOTE: Hex key storage is located on the back of the saw
arm.
 Set motor head and base assembly aside.
BASE
11 — English
MOTOR HEAD
ASSEMBLY
CAP
SCREWS
WASHERS
STUDS
HOLES
Fig. 8