RIDGID R4093 Manual Del Operador página 16

ASSEMBLY
INSTALLING/REMOVING THE FRAME AND
SLIDING TABLE
See Figures 21 - 23.
 Pull the frame lock lever out and turn 90˚ counterclockwise
to the "unlocked position".
 Release the lever.
 Grasp the sliding table firmly and guide the table and
frame onto the rails of the base.
 Holding the table and frame parallel with the base, push
the table and frame toward the back of the saw.
NOTE: The table and frame should move smoothly over
the rollers inside the rails.
SAW
FRONT
FRAME
LOCK
LEVER
UNLOCK
FRAME LOCK
LEVER
SLIDING
TABLE AND
FRAME
Fig. 21
SLIDING TABLE
AND FRAME IN
LOCKED POSITION
SLIDING
TABLE
FRAME
Fig. 22
To lock the frame:
 Pull the frame lock lever out and turn 90˚ clockwise to the
"locked position".
 Release the lever.
NOTE: When the sliding table and frame are installed,
and you push the frame, it will "click" into place. This
is the frame lock lever snapping into a hole in the frame
locking it in place.
To unlock the frame:
 Pull the frame lock lever out and turn 90˚ clockwise to the
"unlocked position".
To lock/unlock the sliding table:
The sliding table has two locking positions. Lock the table
LOCK
at the front of the frame when storing the saw or lock it at
the rear of the frame, near the cutting wheel, when making
cuts that use the rip fence.
 Lock the frame.
 Push in the table lock knob and turn 90° counterclockwise
to the unlocked position to unlock the sliding table.
 To lock the sliding table, push in the table lock knob and
turn 90° clockwise to the locked position and release.
Move the table to the front of the frame until the table
lock knob snaps into place.
To remove the frame and sliding table:
 Lock the sliding table.
 Pull and hold the frame lock lever out.
 Move the sliding table and frame to the front of the saw
and remove.
TABLE
LOCK
KNOB
SLIDING
TABLE
16 — English
LOCK
UNLOCK
FRAME
Fig. 23