Assembly - RIDGID R4010TR Manual Del Operador

ASSEMBLY

UNPACKING
See Figure 5.
This product requires assembly.
 Carefully lift the saw from the carton and place on a level
work surface.
WARNING:
Do not use this product if any parts on the Loose
Parts List are already assembled to your product
when you unpack it. Parts on this list are not as-
sembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result
in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has influ-
enced the settings, refer to specific procedures explained
in this manual.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not oper-
ate this tool until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in ac-
cidental starting and possible serious personal
injury.
ASSEMBLING THE WSUV™ WET SAW
UTILITY VEHICLE / LEG STAND
See Figure 6.
Many of the WSUV™ / leg stand parts are movable. All
hardware must be tightened securely but not so tight that
the utility vehicle / leg stand won't open and close. For easier
assembly, match letter to letter.
 Insert a hex head bolt through the hole at the bend on the
right outer tube (G) and into the lower brace (F). Tighten
securely. Repeat for the other side.
 Place a carriage bolt through the center hole in the outer
tubes (G) then place a spacer on the bolt.
 Slide the bolt/spacer into the inner leg assembly (G) and secure in place using a lock nut. Do not overtighten.
Repeat for the other side.
 Place the center brace on top of the inner leg assembly
(curve side up) with the stop pin under the pedal assembly
latch.
NOTE: The stop pins rest on top of inner leg assembly.
 Insert a carriage bolt through the top hole of the inner leg
assembly then slide a spacer on the bolt. Repeat for the
other side.
 Slide the center brace onto the bolt (F) and secure in
place using a lock nut. Repeat for the other side.
 Place a washer and long cap screw through the rubber
foot. From the underside of the right outer tube, slide
the bolt/foot into the last hole (curved side) of the tube.
Repeat for other side.
 Lay the Ready Rack™ on top of the outer tube and onto
the cap screw / foot. Using a hex key, secure in place
using a nut.
(NOTE: Use long bolts on the outer tubes to secure the
Ready Rack™ to the leg stand and short bolts on the
lower brace.)
 With the curve handle turned downward, secure the up-
per tubes (E and H on the right side, and A and D on the
left side) to the leg stand using carriage bolts, spacers,
and lock nuts. The tube with the diverter valve attached
should be placed on the left side of the leg stand.
 Remove the lock nut and two flat washers from the axles
on each side of the leg stand.
 Slide the flat washer, wheel, and flat washer onto the
axle through the hole in the center of the wheel. Secure
in place using lock nut.
 Repeat with the second wheel.
12 — English