RIDGID R4093 Manual Del Operador página 30

OPERATION
 Position the motor head high enough for the material to
pass through the cutting wheel and low enough for the
cutting wheel to cut through most of the paver.
 Lock the motor head in position.
 Make sure the material is clear of the cutting wheel before
turning on the saw.
 Turn the pump switch to position I or II.
 Turn the on/off switch to the ON position.
 Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
 Hold the material firmly against the miter guide and fence
and feed the material into the cutting wheel to make a
non-through cut.
 When the cut is made, turn the saw OFF and wait for the
cutting wheel to come to a complete stop.
 Move the sliding table away from the motor head and
turn paver over to make through cut.
To cut paver for corners:
 Measure paver and landscaping feature to determine how
much material needs to be removed and how much of an
angle is required for wall corner.
 Using grease pencil and square, draw a mark from the
corner of the brick to the opposite edge at the required
angle, marking all the way around the paver.
 Place the material on the table and firmly against the miter
guide and fence.
NOTE: It may be necessary to remove side splash guard
to make room for paver cut.
 Make sure the material is clear of the cutting wheel before
turning on the saw.
 Turn the pump switch to position I or II.
 Turn the on/off switch to the ON position.
 Let the cutting wheel build up to full speed and wait for
the wheel to get wet before moving the material into the
wheel.
 Hold the material firmly against the miter guide and fence,
move the sliding table and frame toward the end of the
saw, and slowly feed the material into the cutting wheel.
 When the cut is made, turn the saw OFF. Wait for the
cutting wheel to come to a complete stop before removing
any part of the material.
MARK
30 — English
THROUGH CUT
Fig. 50
FINISHED PAVER
Fig. 51