RIDGID R4093 Manual Del Operador página 14

ASSEMBLY
ATTACHING WATER TRAY TO WSUV STAND
See Figure 16.
 Open the WSUV stand as described on page 22.
 Place the water tray on the WSUV stand. Align the holes
in the water tray with the holes in the WSUV stand's
handles.
NOTE: The portion of the water tray with the Ridgid logo
should be on the wheel side of the stand.
 Secure the water tray to the stand using four hitch pins.
INSTALLING WATER FILTER AND WATER
PUMP
See Figures 17 - 19.
The water pump recirculates water from the tray to the
cutting wheel.
 Locate filter slots and pump well in water tray. Pump well
is marked, "PUMP".
 Slide filter into filter slots, as shown.
 Locate the "Max/Min" water flow selector on the pump.
For best performance, start with the flow to "Max" to
control the flow of water over the wheel.
NOTE: Water flow can be adjusted during use by
removing the filter, reaching into water well and turning
flow selector on pump. Reinsert filter.
 Place water pump into pump well.
HITCH PIN
WSUV STAND
PUMP WELL
WATER TRAY
WATER
HOSE
NOTCH
POWER
CORD
NOTCH
POWER CORD
Fig. 16
14 — English
WATER
FILTER
FILTER SLOTS
WATER
FLOW
SELECTOR
WATER PUMP
WATER TRAY
Fig. 17
MAXIMUM
FLOW
MINIMUM
FLOW
Fig. 18
PUMP
WELL
Fig. 19