Break-In Period; Before Starting The Generator; Starting The Engine; Frequency Of Use - Westinghouse iGen4500cv Manual De Instrucciones

OPERATION

BREAK-IN PERIOD

For proper break-in, do not exceed 50% of the rated
running watts (1850 watts) during the first five hours of
operation.
Vary the load occasionally to allow stator windings to heat
and cool and help seat the piston rings.

BEFORE STARTING THE GENERATOR

Verify that:
• The generator is placed in a safe, appropriate location.
• The generator is on a dry, flat, and level surface.
• The engine is filled with oil.
• Gasoline is in the fuel tank.
• All loads are disconnected.
• The ECO switch is in the OFF position.
Fire and explosion hazard. DO NOT move or tip the
generator during operation.

STARTING THE ENGINE

1. Turn the fuel knob to the choke position.
OFF
Note: The generator can be started from the Run position
if warm from operation.
2. Firmly grasp and pull the recoil handle slowly until you
feel increased resistance, then pull rapidly.
14 | Westinghouse Outdoor Power Equipment, LLC
RUN
CHOKE
3. After the engine starts, turn the fuel knob to the RUN
position.
OFF
STOPPING THE ENGINE
1. Turn off and unplug all connected electrical loads.
IMPORTANT: Never start or stop the generator with
electrical devices connected.
2. Let the generator run with no load for several minutes
to stabilize internal temperatures of the engine and
generator.
3. Turn the fuel knob to the OFF position.
4. Allow the engine to cool, then turn the fuel cap vent to
the OFF position.
Note: If there is an emergency and the inverter must be
stopped quickly, immediately move the fuel switch
to the OFF position.

FREQUENCY OF USE

If the generator will be used on an infrequent or intermittent
basis (more than one month before next use), refer to the
Storage sections of this manual for information regarding
fuel deterioration.
RUN
CHOKE