Resetting The Temperature Cutoff Switch - Dimplex XLF50 Guía De Instalación Y Del Usuario

Operation
Brightness
Timer
Factory Reset

Resetting the Temperature Cutoff Switch

Should the heater overheat, a manual limit cut-out will turn the unit off and it will not come back on without being
reset. If the button on the unit is pressed, Er2 will be displayed on the unit. It can be reset by turning the unit off at
the main disconnect panel and waiting 5 minutes before turning the unit back on.
CAUTION: If you need to continuously reset the heater, turn the unit off at the main disconnect panel and call
technical support at: 1-888-346-7539.
Press repeatedly to cycle through the brightness and flicker modes.
Solid H - High Brightness
Solid L - Low Brightness
Cycle H - High Brightness with flickering media
Cycle L - Low Brightness with flickering media
Press repeatedly until the desired number of hours of the timer is displayed. When
this function is active, the fireplace will turn off after a set amount of time. The timer
can be set from 30 minutes to 8 hours in intervals of 30 minutes.
To turn the timer off, press
While the timer is active, press the timer button to see the time remaining.
Press and hold and
factory default settings.
repeatedly until 0 appears on the display.
at the same time for 3 seconds to restore the unit to its
19