Installation Instructions - Dimplex XLF50 Guía De Instalación Y Del Usuario

Installation

Installation Instructions

!
NOTE: Two people are required for installation.
1. Prepare a wall with a framed opening, following the dimensions shown in Figure 3. The fireplace can either be
installed partially-recessed (2x4 frame) or flush-mounted (2x6 frame).
CAUTION: Decorative finishing material (such as brick) should be limited to 1/2" (13 mm) overhang to ensure
adequate flow of heated air out of the firebox area.
CAUTION: This fireplace is NOT load-bearing. Ensure the opening for the fireplace is framed in such a way that
the weight of the building materials will not create pressure on the top of the fireplace.
!
NOTE: For 2"x4" construction where the unit will be partially recessed, it is recommended to use XLFTRIM kit
(sold separately) to accomodate the protruing portion of the fireplace.
!
NOTE: Wiring entry is located on the right side at
the bottom of the firebox. Plan the framing to allow
routing of the power cable to this location.
2. If a trimless installation is desired, remove the
factory trim by removing the screws that secure it.
3. Ensuring a minimum of 18" (47 cm) of slack, route
the supply power wire through a cable clamp (not
included) and in the opening in the back of the unit.
(Figure 4)
4. Lift the firebox into the opening in the frame using the
handles on the back of the fireplace.
5. Using a bubble level (supplied) ensure that the
fireplace is level within the framing. Adjust as required.
10
Figure 3
2" x 6"
5 1/2" (14.0 cm)
2" x 4"
3 1/2" (9.0 cm)
XLF50: 50 5/8" (128.7 cm)
XLF60: 60 5/8" (154.0 cm)
XLF74: 74 5/8" (189.7 cm)
XLF100: 100 5/8" (255.7 cm)
16"
(40.6 cm)
Figure 4
Grounding
Screw
Cable Clamp
www.dimplex.com