Dimplex XLF50 Guía De Instalación Y Del Usuario página 18

Operation
Standby
Flame Effect
Heat
Heat Disable
Thermostat
Control
Temperature
Display
(°C ↔ °F)
Eco Mode
Heat Boost
Themes
Custom Color
18
Press to turn the unit on or put it in standby mode.
When the unit is turned back on, it will retain the previously used settings.
Press to turn the flame effect on or off.
Press to turn the heat on or off.
The fireplace can be operated in heat only mode by turning off the flame and color
effects.
Press and hold and
function. This action must be performed on the hidden touch controls.
When the heat is disabled and either the
display.
Press or to adjust the temperature setting of the thermostat.
When the temperature setting is adjusted, the set temperature will flash for 2 seconds,
then the ambient room temperature will be displayed briefly.
The temperature can be set from 5° C to 37° C (41° F to 99° F).
Press and hold and
performed on the hidden touch controls.
Press to activate Eco mode. In Eco Mode, the heater runs at reduced power to
save energy.
Press to activate Heat Boost and adjust the duration by 5 minute increments,
up to 20 minutes. In Heat Boost, the heater runs at maximum power to quickly
heat the space.
Press repeatedly to cycle through the 8 different Themes:
1 - White
2 - White with orange accents
3 - White with blue accents
4 - Red
5 - Blue
6 - Prism — media bed cycles through colors
7 - Kaleidoscope— media bed cycles through colors at different rates
8 - Midnight mode — media bed lights are off
Freeze the media lights to a custom color.
When in Prism or Kaleidoscope modes (see Themes), press
is displayed to freeze the cycle on that color.
Press again to resume the color cycle.
at the same time for 3 seconds to disable or enable the heat
, , or
at the same time for 3 seconds. This action must be
is pressed, --- will appear on the
while the desired color
www.dimplex.com