Tabla de contenido
Idiomas disponibles
Idiomas disponibles
9. LED Light Kit Assembly.
Remove 1 screw from motor plate on underside of
motor housing and partially loosen the other 2
screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come through
holes in middle of fitter plate. Twist fitter plate to
lock. Re-insert screw that was just removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from from underside of fitter plate
and partially loosen the other 2 screws.
Connect WHITE wire from LED light kit to WHITE
wire from motor housing. Connect BLACK wire
from LED light kit to BLACK (or BLUE) wire from
motor housing. [NOTE: It may be necessary to
push back sleeve on wires to be certain of wire
colors.] Be sure that molex connections snap
together completely.
Carefully arrange wiring within fitter plate. Align
slotted holes in LED light kit with loosened screws
in fitter plate. Twist LED light kit to lock. Re-insert
screw that was previously removed and tighten all
3 screws securely.
Align grooves on shade with nodules on inside of
LED light kit and push up gently on shade. Twist
shade to the RIGHT (clockwise) until shade locks
into place. Pull down VERY GENTLY on shade to
make sure that shade is secure.
If you do NOT wish to use the light kit,
on metal cover and align with nodules inside
light
kit. Gently push up on metal cover and turn
to the
RIGHT (clockwise)
WARNING: Metal cover will be HOT if light is left
on.
locate slots
LED
until it no longer turns.
motor housing
molex
connections
LED light kit
page 9
motor housing
motor plate
fitter plate
LED light kit
nodules
shade
grooves
motor housing
nodules
metal cover
grooves
fitter plate
Tabla de contenido
