9. Light Kit Assembly (Optional).
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted holes
in fitter plate with loosened screws in motor
plate, allowing molex connections from
motor housing to come through holes in
midde of fitter plate. Twist fitter plate to lock.
Re-insert screw that was just removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from underside of fitter
plate and partially loosen the other 2 screws.
Connect WHITE wire from LED light kit to
WHITE wire from motor housing. Connect
BLACK wire from LED light kit to BLACK (or
BLUE) wire from motor housing. Be sure that
molex connections snap together
completely.
Carefully arrange wiring within fitter plate.
Align slotted holes in LED light kit with
loosened screws in fitter plate. Twist LED light
kit to lock. Re-insert screw that was
previously removed and tighten all 3 screws
securely.
Align grooves on shade with nodules on
inside of LED light kit and push up gently on
shade. Twist shade to the RIGHT (clockwise)
until shade locks into place. Pull down VERY
GENTLY on shade to make sure that shade is
secure.
If you do NOT wish to use the light kit,
slots on metal cover and align with nodules
inside
LED light
kit. Gently push up on metal
cover and turn to the
RIGHT (clockwise)
it no longer turns.
WARNING: Metal cover will be HOT if light is
left on.
molex
connections
locate
until
LED light kit
page 8
motor housing
fitter plate
motor housing
LED light kit
nodules
shade
grooves
motor housing
metal cover
grooves
motor plate
nodules