Automated Learning Process./Activating Code; Remote Control Transmitter - Craftmade Envy EVY60 Guia De Instalacion

10. Automated Learning Process./Activating Code.

CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
REMOTE CONTROL
desired, turn wall switch off to any other
TRANSMITTER
(back)
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter. Install one 12-volt battery
(included).
WARNING: Battery is to be inserted with the correct
dimmer
battery
polarity.
switch
ON
Since this fan comes with an LED light kit, the
ON
dimmer switch (labeled ON and D) has been
D
SET
D
pre-set to the "ON" position (ON). If you do not wish
to have dimming capability, please move the switch
to the "OFF" position (D).
Restore electrical power. Within 60 seconds of
restoring the power, press and hold the fan SET
battery
button for 5 seconds or until light blinks twice. Then
cover
replace the battery cover.
NOTE: Remove battery with low or no charge and
dispose of properly.
REMOTE CONTROL
IMPORTANT: Store the remote control transmitter
TRANSMITTER
(front)
away from excess heat or humidity. To prevent
damage to remote control transmitter, remove
battery if remote control transmitter will not be
used for long periods.
I I I IV
V
I I
CAUTION: "DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK. " - When VI
I
disposing of household alkaline batteries, it is best
to check with your local and state recycling or
household hazardous waste coordinators
concerning the specifics of the program in your
area. You may also locate a recycling center by
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or
visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING: Choking Hazard - Small parts. Keep
battery away from children.
WARNING: Battery is NOT rechargeable. A
non-rechargeable battery is not to be recharged.
page 10