Light Kit Assembly - Craftmade Rugged Guia De Instalacion

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

9. Light Kit Assembly.

Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws.
Align slotted holes in shade with loosened
screws in motor plate, allowing molex
connectors to come through center hole in
shade. Twist shade to lock. Re-insert screw
that was previously removed and securely
tighten all 3 screws with a Phillips
screwdriver. [Refer to diagram 1.]
Remove 2 screws from underside of shade
and partially loosen the other 2 screws.
Connect WHITE wire from motor housing to
WHITE wire from light kit fitter and BLUE (or
BLACK) wire from motor housing to BLUE
(or BLACK) wire from light kit fitter. Make
sure molex connections snap together
completely. [Refer to diagram 1.]
Carefully arrange wiring within the shade.
Align slotted holes in light kit fitter with
loosened screws in shade. Twist light kit
fitter to lock. Re-insert screws previously
removed and securely tighten all 4 screws
with a Phillips screwdriver. [Refer to
diagram 1.]
Install 2 medium base 5 watt LED bulbs
(included).
Important: When you need to replace bulbs,
please allow bulb(s) and metal cage to cool
down before touching them.
[Refer to diagram 2.]
Locate 4 screws in hardware pack. Align
holes on top of metal cage with holes on
outer edge of shade. Secure metal cage with
the 4 screws. Securely tighten all 4 screws
with a Phillips screwdriver.
[Refer to diagram 3.]
molex
connections
diagram 1
bulb
diagram 1
shade
screw
diagram 3
page 10
motor
housing
motor plate
shade
light kit fitter
motor housing
bulb
motor housing
screw
metal cage
Tabla de contenido
loading

Este manual también es adecuado para:

Rgd52

Tabla de contenido