Blade Assembly; Light Kit Assembly. Pgs - Craftmade Cole Guia De Instalacion

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Time Saver: Washers for blade attachment
screws can be set on each screw prior to
installing blades.
Locate 9 blade attachment screws and
washers in hardware pack. Slide a blade
through one of the narrow, rectangular
openings on the motor housing, aligning
holes in blade with holes in blade arm, which
is pre-attached to the underside of the motor
housing and located inside the motor
housing--refer to drawing at right. Insert 3
blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for remaining blades.
NOTE: Tighten blade attachment screws
twice a year.
9. Light Kit Assembly.
Remove 1 screw from motor plate (on underside
of motor) and partially loosen the other 2 screws.
Align slotted holes in fitter plate with loosened
screws in motor plate, allowing molex
connections from motor housing to come
through hole in middle of fitter plate. Twist fitter
plate to lock. Re-insert screw that was just
removed and tighten all 3 screws securely.
["Light Kit Assembly" continued on next page.]
motor housing
(view from underside)
motor plate
molex
connections
page 7
blade arm
blade
blade attachment
screws and washers
motor
housing
fitter plate