Light Kit Assembly - Craftmade Stockman STK52 Guia De Instalacion

9. Light Kit Assembly.

Remove 1 screw from motor plate (on
underside of motor) and partially loosen the
other 2 screws.
Align slotted holes in fitter plate with loosened
screws in motor plate, allowing molex
connections to come through center hole in
fitter plate. Twist fitter plate to lock. Re-insert
screw that was previously removed and
securely tighten all 3 screws with a Phillips
screwdriver. [Refer to diagram 1.]
Remove 3 screws from post located on
underside of fitter plate.
Connect WHITE wire from motor housing to
WHITE wire from the LED light kit and BLACK
(or BLUE) wire from motor housing to BLACK
wire from LED light kit. Make sure molex
connections snap together completely.
[Refer to diagram 2.]
Carefully arrange wiring within LED light kit.
Align holes in LED light kit with holes from
post located on fitter plate. Re-insert screws
that were previously removed and securely
tighten all 3 screws with a Phillips
screwdriver. [Refer to diagram 2.]
Align grooves on glass shade with nodules on
inside of fitter plate and push up gently on
glass shade. Twist glass shade to the RIGHT
(clockwise) until glass shade no longer turns.
[Refer to diagram 3.]
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
motor plate
fitter plate
diagram 1
fitter plate
molex
connections
diagram 2
diagram 3
page 8
motor housing
molex
connections
motor housing
LED light kit
post screw
motor housing
nodule
groove
glass shade
post