Wiring - Craftmade Envy EVY60 Guia De Instalacion

5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging ball
rest on the hanging bracket. Turn the hanging ball slot until
it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the stepladder
in place and to help lift the fan up to you once you are set
on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be necessary
to use a heavy duty wood screw, washer and lock washer
(not supplied) with the safety cable loop. If necessary,
adjust the loop at the end of the safety cable. The loop at
the end of the safety cable should just fit over the threads
on the wood screw. Test safety cable by pulling on loose end
of safety cable with pliers. If the safety cable slips, the loop
must be adjusted smaller. Extra cable slack can be left in
ceiling area.

6. Wiring.

WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the diagram to the
right, please use a qualified electrician.
Note: Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When downrod is secured in place on the
hanging bracket, WIRE THE RECEIVER with wire
connectors provided as shown in diagram at
right.
Tip: While you are wiring, keep in mind that
wires must not obstruct receiver from sliding
into hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push taped wire
connectors into outlet box. Let antenna rest
outside of hanging bracket.
ground (green
or bare)
black
white
red
yellow
gray
from fan
from
receiver
gray
yellow
red
white
blue
(wiring for receiver)
page 7
wood ceiling
joist
safety cable loop
safety cable
hanging bracket tab
hanging ball slot
motor housing
white supply wire
black supply wire
ground (green or bare)
ground (green)
white
from ceiling
from receiver
antenna
white
AC IN N
black AC IN L
receiver ground (green/yellow)
wood screw
and washer
black
*