Blade Assembly; Light Kit Assembly. Pgs - Craftmade Wyman WC42-3 Guia De Instalacion

8. Blade Assembly.

WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade arm up to blade and align holes. Insert
3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor
locks are installed with blade arm screws,
discard plastic motor locks (save blade arm
screws and lock washers to secure blade arms).
Align blade arm holes with motor screw
holes and attach blade arm with lock
washers and blade arm screws. Before
securing screws permanently, repeat this
procedure with remaining blade arms.
Secure all screws.
NOTE: Tighten blade arm screws twice a year.
9. Light Kit Assembly.
Locate BLUE (or BLACK) and WHITE wires
in the switch housing labeled FOR LIGHT.
Remove and discard plastic that holds
these 2 wires together.
Remove 3 screws from light kit fitter.
Next, locate WHITE and BLACK wires in
light kit fitter.
["Light Kit Assembly" continued on next
page.]
plastic
motor
lock
lock washers
switch
housing
white wire
white wire
page 7
motor
housing
blade attachment
screws and washers
J
blade
blade arm
blade arm screws
motor
housing
blue (or black)
wire
black wire
light kit fitter