Reversing The Door Opening Side; Hot Surface Warning; Preparation; What To Do For Energy Saving - Beko B5RMLNE444HX Manual Del Usuario

4.6 Reversing the Door Opening
Side
The door opening side of your refrigerator
can be reversed according to the place you
put it. When you need this, you should defin-
itely call the nearest Authorized Service.

5 Preparation

Read the "Safety Instructions" sec-
tion first!

5.1 What to Do for Energy Saving

Connecting the product to electronic
energy-saving systems is harmful, as
it may damage the product.
• This refrigerating appliance is not intended
to be used as a built in appliance.
• Do not keep the refrigerator doors open
for long periods.
• Do not place hot food or beverages into
the refrigerator.
• Do not overfill the refrigerator; blocking the
internal air flow will reduce cooling capa-
city.
• Using the below drawer when storing is
strongly recommended.
• Make sure the foods are not in contact
with the cooler compartment temperature
sensor described below.

4.7 Hot Surface Warning

The side walls of your product are equipped
with cooler pipes to enhance the cooling
system. High pressure fluid may flow
through these surfaces, and cause hot sur-
faces on the side walls. This is normal and it
does not require servicing. Be careful when
you contact these areas.
• If they are in contact with the sensor, en-
ergy consumption of the appliance might
increase
• Food shall be stored using the drawers in
the cooler compartment in order to ensure
energy saving and protect food in better
conditions.

5.2 First Use

Before using your refrigerator, make sure the
necessary preparations are made in line with
the instructions in "Safety and Environmental
Instructions" and "Installation" sections.
• Keep the product running without placing
any food inside for 6 hours and do not
open the door, unless absolutely neces-
sary.
• The temperature change caused by open-
ing and closing of the door while using the
product may normally lead to condensa-
tion on door/body shelves and glassware
placed in the product.
A sound will be heard when the
compressor is engaged. It is normal
for the product to make noise even if
the compressor is not running, as
fluid and gas may be compressed in
the cooling system.
It is normal for the front edges of the
refrigerator to be warm. These areas
are designed to warm up in order to
prevent condensation.
EN / 15
EN
FR
ES
PT